Review on 💡 Inrush Current Limiters 2Ohms Ametherm: Efficiently Handle High Current Surges by Ryan Koser

This solved the No Power problem with my Aquarite chlorine generator board. The pins were slightly wider than the original part, but I was able to carefully bend one of them in and solder it on. Following other tips I've read about this repair, I cut the old part off leaving a few millimeters of open contact and soldered it to these posts. Unless you have a heavy duty soldering iron it will be impossible to desolder the original part. One thing I didn't do but wish I had cut the pins about halfway through on this part. It's quite high and the lid touches it and can't be screwed back on all the way. In order to solder on a flat surface, you need to remove the original circuit board. I've tried doing this without removing the board, but unless you have help you can't get good solder on a vertical surface.