They are fine. They're quite bright, not as bright as I expected, but I think that's because they're more "flooded" and scattering too much light instead of concentrating it where I want the light to be. If they are 30 degrees like others say (vs. 60 degrees for a tide) to me it's not a 'spot' but still a tide (i.e. narrow tide vs. wide tide). They would make great reverse lights, but they don't illuminate things too far ahead. They're sealed devices, so the lenses are permanently bonded, and it's impossible to open one of them, most likely without destroying them. That. So if one or more individual chips fail, they cannot be repaired or replaced. If I had known that, I don't think I would have gotten them. The fastening material also leaves a lot to be desired. The 2 screws that attach the bracket to the lantern are too long. You'll need a couple of washers (preferably a lock washer or two!) to keep them from being screwed in too deep and touching the body of the light. As they are, they will sink and remain free. In addition (!) the supplied nuts are too small and twist when tightening the screws. Maybe 1mm more and it's "captive screws" and you'll be fine, but as it is you'll need to wedge a small screwdriver blade in to hold the nut in place while tightening or they'll just spin . As for the mounting bracket itself, I'm afraid the rather flat tabs are supposed to hold the hex bolt in place, if you just over tighten the tabs will "rip off" and end up spinning. I haven't installed them yet, but I'll be careful! Looks like I'm picking on them, but when you see what I see around here quite often, which is high beam headlights with broken lenses pointing at the pavement etc, you might not care if they're condensing inside or not You end up with 2 out of 6 LEDs working. I used to take narrow high beam headlights with industrial mounts and spend half an hour aiming them at a building in a parking lot, so yeah, I'm picky. :)
Motrobe For 2016-2023 Tesla Model Y Model 3 Model S, 2016-2021 Model X Integration Ultra-Brights Step Led Puddle Door Lights Never Fade With Extension Cord, Pack Of 2
35 Review
Short Stubby Antenna For Mazda Miata 2006-2022 - 3.8 Inch, Compatible With CravenSpeed
29 Review
Smart lamp Yandex E27 8W 900lm WiFi RGB YNDX-00018
70 Review
Upgrade Your Light Bar With NAOEVO 14AWG 240W Custom Wiring Harness And 6 Modes Light Bar Controller
29 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review