After trying some new compression fittings to attach my 0.62" OD and found they were leaking ( the old ones worked fine!), I decided to go the other route with this 1/2" stud brass female fitting. Due to size and material differences, you will need two additional items to stop the leak: a 5/8" "Hose clamp and an e6000 hose. Install everything dry so you know it will work. The .62" OD hose slides over the tip, but tightening the clamp is not enough as the hose is stiffer than a Rubber hose is, so liberally lubricate the beard of the e6000 and reassemble, tighten the clamp and wipe away any excess adhesive he off Leave to dry for 48 hours before use to allow the adhesive to fully cure. The glue in this case is more of a liquid sealant that makes the connection airtight. I always switch off at low temperatures and so far so good.
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review