Fuses on dash panel but with bus and back to breakers I don't come across fuses very often but when they happen it is always at night, with no light, and seems to deter any replacement that is supposed to have been. In order not to blow fuses frequently, burning is probably more appropriate. I had blown a mate's car because the fuse box wasn't set properly for the full 2 minutes after the car started. He almost made it to the main road before the entire driver's side of the car burst into flames. He had to open the door and jump over the flames that came out from under the carpet where the inscription lay. The trunk contained a secondary battery with its power and ground leads connected to the main battery to eliminate system noise. Everything was initially fused to keep those lines safe, but some sound expert eventually told him he didn't need to be fused like that. He removed all the fuses and only reinstalled one fuse block, not isolating anything on the bottom of the block and dangling it from the main block. The nets as they were were too close to the turbo and melted to bare copper. After the guy improved the system to randomly turn it off and also improved the noise resolution by boosting it back up, my buddy came over to check it out again. I immediately noticed the wires melting and as a quick fix I painted them with liquid tape and sealed them with duct tape. The mesh had melted so much that I didn't notice the dangling and exposed block. By pinning and moving the main line, the block had to find the right spot to enter the short position. It wasn't long before a short circuit caused the 0-gauge power and ground lines that ran between the primary battery under the hood and the secondary battery in the trunk to each ignite at the very bottom. If you've never had an electrical fire, here's a tip: neither water nor a fire extinguisher will put it out while the power source is still feeding it. Another 5 minutes passed before someone came and told me that the car was on fire and that I couldn't get there, whereupon he and the Good Samaritan turned to me from the smoking car, saying they had just put out the fire. The black smoke that billowed from it seemed to suggest otherwise, and at that moment flames erupted from the open driver's door beneath his dash, into which he then poured half an ounce. Bottle of water to no avail. Luckily he popped the hood up when he saw smoke coming out and the trunk electronics shorted it out so we could pry out both batteries. The battery posts melted and the connections to them appeared to be welded, the batteries caught fire but they still gave juice and stoked the fire until they were yanked from the car. It burned heavily and quickly burned out all the car's electrical system. So I switched to Brecher and never tried the German Farfegnugen again. Breakers lead by 2 points.
🔌 Enhance Your Electrical Work with Klein Tools 69411 Accessory Adapters
7 Review
🔌 Bussmann MDL 2 Glass Delay Slow Blow
8 Review
🔌 Bussmann GMA 5A Acting Cartridge Listed: Reliable and Efficient Cartridge Fuse for Your Automotive Needs
7 Review
⚡ 20 Amp Single Circuit Breaker for Q120
8 Review
Adjustable AC Current Sensing Switch: SZC23 No AL-CH Model, 0.2A-30A Range
14 Review
🌀 NuTone 5901A000 Blower Wheel Assembly: Superior Efficiency and Performance
9 Review
Universal Rotary Cam Selector Latching Switches - VictorsHome Changeover Switch LW28-32 With 3 Positions, 12 Terminals For 690V, 32A Capacity
9 Review
5Pcs 19Mm 12V 24V Waterproof Latching Push Button Switch With Wiring Harness And LED Indicator Light, Pre-Wired SPDT Self-Locking 4 Pin Marine Metal Switch For Boats Cars Trucks (Blue)
22 Review