Review on 🔋 Sunway Solar Panels Charge Controller 12V Battery Regulator 7A - Enhanced Safety Protection for 12Volt Solar Power Battery Chargers, Solar Trickle Chargers & Maintainers, and Solar Powered System Kits by Timothy Richmond

Works as advertised. Use it to regulate your Go Zero 10W solar panel. The controller installed on the panel wiring burned out so I cut it off, reconnected the wiring and installed that controller. I had to buy some reverse polarity connectors as my panel had the opposite connector configuration as the controller was connected. You need to make sure that + to +, - to -. Most people will tell you that you don't need a controller for a solar panel that only produces 10W, but given that I originally had one and the fact that it produces 20V DC in direct sunlight, I did it anyway. In addition, this description of the controller said that it works well with lower powered panels. Anyway, I always keep my Red Top battery fully charged in my Jeep. When I first installed it, the battery voltage was 11.3 volts; After 24 hours it was 12 volts. So it is charging and not just keeping a battery that is not very weak.