🔧 100pcs - 10mm Nylon Clips Plastic Push Type Rivet Retainer Fastener for Honda Acura Bumper Pin Fender Flare Review

These types of clips almost always break when you try to remove them. Most new Hondas require the bumper to be removed for many repairs, so it's best to have a large supply. OEM clips in it fit very well and did not differ much.

PROS: o Cheap o Arrived "unassembled" MINUS: o None yet. Worked well on the bumper cover on our 2004 Subaru Outack. The lack of a center rivet set on the outside of the rivet made installation very easy, then just snap the center piece into place and the job was done. I haven't tried deleting them as I have no reason to but I can't imagine them coming out with much trouble.

Love these 10mm nylon clips. I use them frequently when servicing my 2003 Subaru Forester and 2005 Honda CRV. These parts are consumed during maintenance when the old clips on the car break when removed. The wing clips are difficult to remove without disassembling or damaging them. I find that many additional new clips speed up assembly of the car; I don't need to fix pulled out damaged terminals. These new clamps cost 1/10 of the OEM clamps. They're inexpensive, so having lots of extras on…

After replacing the fan thermostat in my Honda S2000, most of the old pressure clamps were broken. these fit perfectly. I also like that they came unassembled (no center pin pre-installed) because it was much easier to line up the holes, insert them, then insert the center pin and slide it together to lock it. If trying to insert them with the center pin already installed, it is difficult to apply enough force to get things in place as the center pin will expand before the spreader can slide…

I have a 2015 HONDA ACCORD V6 COUPE. 100k miles. Over time I damaged the fender. when I replaced it. The old clips never worked properly again. They unscrewed and I damaged the liner again. The fender liner is connected to the lower fenders and bumper cover. All 3 of these liner/body protectors are connected to each other and to the frame. They must be executed correctly or the entire system will fail. This time I needed 3 different types of fasteners and fastened everything correctly. These…