Review on 🔧 100pcs - 10mm Nylon Clips Plastic Push Type Rivet Retainer Fastener for Honda Acura Bumper Pin Fender Flare by Ryan Barton

I have a 2015 HONDA ACCORD V6 COUPE. 100k miles. Over time I damaged the fender. when I replaced it. The old clips never worked properly again. They unscrewed and I damaged the liner again. The fender liner is connected to the lower fenders and bumper cover. All 3 of these liner/body protectors are connected to each other and to the frame. They must be executed correctly or the entire system will fail. This time I needed 3 different types of fasteners and fastened everything correctly. These clips and two other required types will button your Honda up tight! This item is 10mm clips that will fit any hole UNDER the car. Probably a dozen holes. Complete each! a missing clamp relieves the others and the floor sags, rattles a lot and doesn't last long. With 100 you have enough to fill them all. I even replaced the original thin clips and they snap into place much tighter. For the inside of the wing you can use a bunch of 8mm push pins (6-8 on each side?). Finally, on the firewall side, use square rivets (3 on each side). Both are available from Revain: 1.8mm - for inner fender liner - 8mm GOOACC nylon bumper rivet 90682-SEA-003 - square clips - no center post2. Rexka 40 pcs. fender apron lining fender holder clamp hub holder 90682-SEA-003 Now the car is like new again in terms of appearance and front equipment. It's great to see so many cars on the road with flapping interior panels or sagging floors. This is easy to fix with the right parts.