1/2" Hose Barb Beduan 3 Way Shut Off Brass Y Shaped Ball Valve - 2 Switch Control Review

Haven't gotten to use yet as I'm building my generator shed. I've gotten the Demand regulator (Nash Fuel) so I can use Propane or Natural Gas. This lets me choose which I want use. One for NG and the other for Propane>> Don't have no worries about cleaning a carb. with old gasoline jelled and dry in it! Just fire it up and back to normal. lol No Gasoline runs (waiting in line etc.), just open a valve, start generator and go watch TV. LOL,lol Pa ps: All things working- refer, TV, comp., etc.

Came quickly and with all parts. Seals are a bit fussy to get in. Really make sure it’s seated properly or you’ll have a leak. The inner small port of the seal needs to fit perfectly. One of the yellow plastic screw covers fell off and won’t easily snap back into place. It’s not a deal breaker though.

I used valve to converge 2 drain lines, but the water was flow was not as expected. Turns out the knobs wear at the socket/valve interface and the built in 'stops' only make you think you changed the valve position. Pulling the cap and tightening made no difference. Very disappointed. Apparently there is no recourse for a refund at this point either.

First one of the valve handles fell off, then I noticed leaking and the brass Y had actually cracked! All this after only 3 months of being installed. Leaked water everywhere. Is this really made out of brass?

fit a 3/8 fuel hose. You can get about half way on to the barb. Spent some time on it to get it that far but with the clamps tightened down i don't think the line is coming off.

I put this on a small air compressor for my pond for aeration to bleed off the air if needed so I didn’t have to unclamped the hose. Works great

The first one I ordered was bad and wouldn't shut off. They replaced it and the second one was ok but for some reason the handles are extremely wobbly but I think it's supposed to be. Its a good affordable part with very little other options to choose from. I also had to loctite the threads before use.

This is garbage. It’s been installed for about 3 weeks, ahead screws with holes valve handles in place are rusted and stained. One fell out, brass is very low quality pot metal and is stripping where the handle is screwed on. Don’t waste your time. This is typical Chinese crap.

I'm in research and this little product was just one of those products you never know you really need. It was a the perfect part for the project I was working on and it really made my life easier. Thank you for making a simple but useful product, it's going to make so many people like me thankful that we get the job done and done right. Great product, great brand, and very cleanly manufactured.

All the fitting leaked, cheap hose clamps, one of the brass fittings was cracked and I lost a full bottle of welding gas because of all the leaks. Don’t waste your money.