🔥 Upgraded Gloss Black Seat Frame for Honda Ruckus Lowboy (2003-2020) Review

Overall not worth the money. Looks good but the fit isn't great. They also give you four pieces of gear to secure the seat, but one had a manufacturing defect.

Excellent fit, just leave all the bolts half loose until the whole frame is level. I didn't use the crappy rivets that came with the kit, personally I just don't care about rivets. I STRONGLY recommend this, it's the lowest frame you can use and delivery is guaranteed within two days 👍

I was worried I would have to remove the default plastic to install this mod as many people either do it or say they need it. I left everything in place and just installed. I had to apply some pressure to the rear right side to push the plastic down and secure it with screws, but it's perfect. The ride was much more stable because as a 6ft 3in man I had to fold the seatback and move down and it did just that. It's a bit strange at first as to where to put my feet after installation, but to be…

This seat frame just installed easy to install but does not come with instructions. You will need to drill the seat to align it with the frame of the seat bolts (easy), just don't over drill. The seat bolts on so won't raise anymore, but they sell aftermarket mounting kits so you can raise the seat. Jst4shwrucks.com sells a reclining seat kit. For the money this is a good seat frame but I have to read carefully and realize that the seat doesn't tip over. If I were to do it again I would buy a…

You must mount the seat to a custom frame (the seat can no longer be flipped). So remove the small wire clip that is attached to the bottom of the seat. Once you've removed the seat from the stock frame and built the lowered seat, you will need 4 screws (I used heavy ones) to bolt the seat onto the new frame (I already have the mounting holes for you). Just drill through and you're done. Took me about 20 minutes (from start to finish) and I'm back. I used two longer screws to drill deep into…