🚀 Enhanced Performance Proform 67217 Carburetor with 750 CFM, Mechanical Secondary, Annular Booster, Aluminum Square Bore Main Body - Includes Gaskets Review

Casting looks and feels a bit bad. I think it's the same housing used for quick fuel carbs (were from another build) carb works great and responds great, haven't tried it on the track yet but hope it's full. I think it sometimes pays to hold on to your old parts.

Molding looks and feels a little bad I think it is the same case used for the almost Fuel carb is used, molding has both Proform and QFT marks, I used QFT base and blocks (they were from a different build), carbs work great and are super responsive. Haven't tried it on the track yet but I hope it's full. I think it sometimes pays to hold on to your old parts.

Unfair conversion of old Holley carburettors. If your secondary link is connected to the main unit, you will need to buy a new base with it

The casting looks and feels a little bad. I think it's the same housing used for quick fuel carburetors. There are both Proform and QFT marks on the casting I used the base and QFT blocks (they were from a different build), the carb works great and responds great, haven't got it on the track yet tried it, but I hope it's full. I think it sometimes pays to hold on to your old parts.

Works great but probably more than I need. The air supply without a dynamometer is not regulated. Also, it doesn't have an attached vacuum source. It probably says so in the description, but it would be nice to have one. I would definitely buy it again. Everything worked fine and looks good. It also has QFT on the side so I'm assuming it's the same version as Quick Fuel.