Header banner
Revain logoHome Page
๐Ÿ”ง acdelco professional engine water pump 252-917 logo

๐Ÿ”ง ACDelco Professional Engine Water Pump 252-917 Review

4

ยท

Very good

Revainrating 5 out of 5ย ย 
Ratingย 
4.8
๐ŸŒก๏ธ Engine Cooling & Climate Control, ๐Ÿ› ๏ธ Replacement Parts

View on AmazonView on ะฏM

Media

(1)
img 1 attached to ๐Ÿ”ง ACDelco Professional Engine Water Pump 252-917

Description of ๐Ÿ”ง ACDelco Professional Engine Water Pump 252-917

All Makes water pumps fit GM vehicles as well as a wide range of non-GM vehicles. Thoroughly tested for reliable, leak-free performance. Coated seals support seal longevity and durability. Heat-treated shaft assemblies provide superior strength and durability over non-treated assemblies. High-quality bearings are permanently sealed and lubricated for greater durability and long life.

Reviews

Global ratings 4
  • 5
    3
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

SUPERIOR QUALITY - WATER PUMP

This water pump is a perfect match for my Jeep JKU. Excellent quality pump and seal. Looks great in front of the engine. Make no mistake with AC Delco products.

Pros
  • Coated seals ensure seal durability and reliability
Cons
  • Upgrades available

Revainrating 5 out of 5

Fits 2010 Jeep Wrangler Unlimited 3.8L

Perfect fit for my 2010 Jeep JKU. It also appears to be of better quality than the original MOPAR it replaced. The original has plastic blades, this one has metal blades. As far as I can tell it works perfectly for the first 1000km.

Pros
  • High quality permanently sealed and lubricated bearings for strength and durability
Cons
  • Repair

Revainrating 5 out of 5

Excellent fit for 2010 Jeep Wrangler 3.8L

Although this is a Delco AC it fits perfectly on a 3.8L Mopar block and is much cheaper than the Mopar equivalent. Note that this pump comes with a fabric seal so you will need sealant and the bolts holding it are only torqued to about 8ft/lbs so you will need a very light torque wrench to get the bolts back up to factory specs bring. The point is not to over tighten these bolts, not that they should be tightened to exactly 8 ft/lbs. If you are draining coolant to replace the water pump, youโ€ฆ

Pros
  • Heat treated shaft assemblies provide greater strength and durability than raw assemblies
Cons
  • Compatibility

Revainrating 4 out of 5

Works great on my 2011 Jeep Wrangler

Fits as a replacement for my water pump on my 2011 Jeep Wrangler. to ensure a good seal. Be sure to check the torque requirements as the bolts break fairly easily. I think the torque is only 9 ft.lbs. I wouldn't reuse the screws for this as they are likely to wear out and break off. I broke one of these removing the water pump and I've heard that old bolts often break. I removed the water pump and showed 1/4" stud bolts. DO NOT attempt to use a vise as removing them will mess up everyโ€ฆ

Pros
  • Water pumps of all brands will fit GM vehicles as well as a wide range of other brands vehicles
Cons
  • Hardware