ACDelco PT1994 Professional Courtesy Pigtail Review

Plastic with rips and tears on one side when I connected it to the dimmer. All three wires are black, so prepare your car's wiring diagram when connecting.

Works as it should but one of the clips broke during installation. I read that this is a problem before I bought it. So I could be gentler, but it still stays securely in place.

As other customers have said, the ears are brittle. I had a pause trying to press the back of the switch. You need to use some softer plastic. Although it works fine.

. I pushed it onto a switch I bought at the same time and one of the clips broke . It also holds without, but very cheap plastic. It's a wired connection and it works, but I'm disappointed with the quality.

I'm sure the wires are too thin for this application. The high beam cable from my switch is much better than the one on the plug, so the plug gets hot after a while. The problem is certainly not in the LED headlight or in the relay system. BUT it works, so maybe I'm wrong.

There aren't that many of these parts from a quality manufacturer. Unfortunately, due to the lack of quality materials used to make these parts, I worked as intended, but again one of the terminals broke when I simply pushed it onto the switch. If I didn't need the part I would send it back.

Genuine ACDelco wiring harness for parking light switch on older vehicles. I did the swap over the winter months. During assembly, one side of the locking pins broke off. Additionally, all 3 wires are black and not color coded to match existing wiring.

Product was as described but when I plugged a dimmer into the harness one of the clip's dog-ears broke. I am very dissatisfied with my purchase. I'm trying to restore a 1982 Chevy K20 and I'm trying to replace it as close to OEM as possible so the harness terminal snaps into place once I connect my dimmer to it after spending time soldering it. I was very angry!