📲 ADT-LINK MicroSD TF Extension Cable: High-Speed SD Card Reader Adapter with Stable No FPC Card Reading Test Line - Up to 104MB/s Review

Use German patented imported wire, use high-quality gold-plated connectors, high-frequency support UHS-I stable transmission. The PCB is made of high-quality materials with high frequency and low resistance. The PCB is made of precision. The PCB uses high TG plates. The thickness of the copper material is thickened to 1oz. The gold-plated connector has good electrical conductivity, which can reduce the lag or read and write failure caused by the increase of oxidation.cable length of 3~30cm supports full speed of uhs-i high-speed card;3~80cm supports SD normal card full speed. Differential signal no via design, no CAF micro short circuit phenomenon, high-speed signal data transmission, no parasitic capacitance and parasitic inductance signal attenuation interference, power circuit strengthened wiring design, PCB board miniaturization design, can reduce mechanism interference , No card hardware, easy product installation. Strengthen welding at the metal welding point during production. And put on the heat shrinkable tube protection, the product is sturdy and reliable, and there will be no disconnection problems. The products are well made, stable, reliable and durable. Application: GPS navigator, ROCK Pi 4 raspberry Pi MCU development board, machine equipment, etc. need to extend the SD card to use outside the machine.