🔧 4-Pack Oval Cooler Sliding Feet with Screws Replacement for YETI Tundra Models 35 45 65 75 110 Cooler Accessories - AIEVE Sliding Feet for YETI Tundra Cooler (Black, Cooler Not Included) Review

Works great! We use our chiller as an entry point into the galley of our trimaran, which makes using chillers as intended so easy.

Removing the originals was fine and broke the pair but that was to be expected anyway and the new ones that slip installed easily in under 10 minutes.

The screws supplied appear to be long but are not, a pack was missing so if needed #6 x 1 stainless steel will do as expected but pull her no boots on yet.

This is so important for Yeti coolers if you use them for camping! The built in rubber feet are great for staying in place, but if you ever need to drag the cooler in and out of your car you'll save so much effort to do what you want!

I keep my Yeti 65 in the back of my truck all the time. I have an old rubber floor mat. It's not that grippy anymore. But with the rubber feet of the Yeti cooler or similar coolers, it is difficult to install and remove the cooler. These new high quality plastic metal legs screw in easily with stainless steel fasteners. And these assholes are going nowhere. Now I can easily pull out my cooler, but it's not that easy to keep it from sliding into the bed of your truck. You grab it right

Fairly easy to install, much harder to remove Stock rubber feet. Use a couple of screwdrivers to pry them up and they will pop out. I was a little reluctant to screw the screws into the bottom of the expensive cooler, but the screws were just the right size so they wouldn't protrude into the cooler (that would be bad). Don't overdo it by tightening them or they will break. I almost used a two part epoxy to glue them on but so far they are holding up pretty well. Definitely makes it easier to…