🔌 Alpha Rider Ignition Coil Harness Connector Repair Kit - A4 A6 GOLF Jetta Passat Polo SHARAN Touran Touareg Transporter Review

Good fit and quality. Everything you need to replace broken connectors, except wire covers that run through the back panel. I wish they had come with them but I was able to reuse mine.

Quality product although terminals are present as factory cables do not match the new updated plugs here. I had to buy a crimping tool, but everything worked out.

The first one was tough. After hearing a faint click, it became a lot easier. I'm very glad I don't have to buy a new belt. Saving ends for later as you can reuse the existing clips.

Please note that this is not a plug and play installation. You must completely remove all connectors. Just be aware that it will take a few hours. I suggest doing this one wire at a time unless you have a detailed schematic. I installed them on an Audi Q5. Much better than the factory connectors that completely fell apart.

I bought these for my '09 Audi A4 2.0t and try as hard as I could I couldn't fit the original pins into these connectors. So I tried twisting them different ways and just kept bending the wires. So I had to cut each clip individually and replace them with the ones that came with the kit. I wouldn't mind, apart from the lengthy process. Because there is not much spare wire. If you must do this, make sure you cut the wire right after the clamp.

get a decent depinning tool and you're done. This kit comes with metal sleeves and a rubber gasket if you want to replace them, but this part is usually fine. If you use a pin remover and pull out the old ones, the new connector will snap into place. They appear to be almost identical to OEM except for a few brand names. May I suggest buying a heat shield to try and extend the life of these new ones.

I bought this Ignition Harness Replacement Kit in the hope that I could quickly and easily repair faulty parts on my B5 (2001.5 Audi A4 Quattro 1.8t). The price was so cheap that I had to try it before switching to any OEM parts. In retrospect, I should have just gone to the landfill. The wiring harness electrical contacts did not match my car and ended up causing a huge headache. I did the repair but needed additional parts in addition to this purchase. If only it were a little higher quality…

This set doesn't help you put old pins in new cases: the new cases require smaller pins (see photo: new pin at right) and don't help with the old big pins fit. While this may not be a problem for you, when I tried my pin removal tools on old connectors, I found that they were brittle and all snapped instantly. This is probably due to their age and the high temperature of the environment they work in. When the old case collapsed, I was able to easily pull the old pins back out. Suggestions: 1…