🏍️ ANKIA 40-LED 40W Red Motorcycle Tail Light with Brake, Turn Signal & License Plate Bracket – Perfect for Harly Motorcycle Street Bike Cruiser Chopper Review

Replacement Custom Headlight Kit. The clear plastic had faded and was invisible in daylight. A very nice sentence. The LEDs are bright enough to be seen in direct daylight. Installation was a breeze as I have custom mounts. The only thing to watch out for. License plate slots are NOT wide enough for standard California motorcycle license plates. So you have to drill new holes in the plate holder. Check photos for brightness. They were taken with the sun behind me shining directly into the…

It took a long time to install but looks good on my V-Star now. Here are my problems: 1. Mounting screws were too long.2. The screws holding the lantern to the frame were also too long.3. The license plate bracket is not suitable for American motorcycle license plates, so new holes must be drilled.4. It took a lot of debugging, but I hooked it up correctly (see image). 5. The license plate is at a really vertical angle so I had to bend it and then repaint it to keep it rust free. Resistors must

Both thin and cheap, the wires on this product turned out to be 1 inch too small for my application. The product and the holes on the standard MC plate are not even tight. I had to close plate ANKIA, use longer and better quality cable and use larger plate bracket for US application TIP when changing from standard (old) to LED headlights, there must be no standard bulbs in the circuit, otherwise the turn signals won't work. Had to unplug driver indicator bulb in dash for it to work. Also, you…

Nice little light, wish it was a little bigger but worked great, had to make my own mounts to fit the light on my bike, love it has everything you need for the rear even the license plate light could be a bit brighter but overall not bad thats why i gave 4 stars and also the license plate mounting holes don't match up with the license plate holes, nothing scary, you can drill your own now let's do it review us, maybe i will give 5 stars as i like it. ***Update**** The item literally fell apart…

I wanted to clean up the back of my bike and it worked for me. It wasn't plug and play. I had to make modifications to the bike and the device itself (the wires were WAY short). Although it looks good I have to admit! Oh, and there's no way to use the license plate bracket on US license plates without piercing them. Even after drilling it couldn't clean the fender so I decided to remove it entirely. I installed it on my 2000 Honda Shadow Spirit VT1100C. I had to drill holes in the fender as the

Where to start? Well I bought this item to fit a 2000 Yamaha Vmax and that's how it worked. First, the unit itself has a license plate bracket that conflicts with a Yamaha OEM part. If you want to use this unit fully you will need to modify the Yamaha part to accommodate it by cutting the inner metal of the rear fender to completely remove the OEM license plate bracket (I had a spare fender part so I have it done it with no problems). that's because I can flip this mod if I want to). Secondly…