🔌 ANTOBLE Standard Central Vacuum Wall Inlet Valve Cover Plate for Beam Central Vac - White Round Door (2 Pack): A Must-Have Accessory for Effortless Cleaning Review

These white plates look very nice but the screws holding the wires are so short and delicate that they don't always tighten. The threads are too thin to screw into the plastic so the plastic threads can be easily pulled off. I had several connections that required 2 wires twisted together and the screws that came with them would not thread at all because they were so short. I was able to get it to work using screws from the slightly larger original plates. Otherwise they look good and work…

This is a quick and easy upgrade to old yellow center vacuum inlet panels. However, attaching the wires to the plates is troublesome. Don't loosen them enough and the wire will not wrap around the terminal screw. Loosen it too much and the device will fall apart. The difference between these two extremes is very small. One had its pin fall out and was never found, the other had its spring fail to return, rendering both records unusable. After replacing two that I broke on the first attempt to…

Installation problem. The replacement socket has two screws that act as terminals for a low voltage switch that turns the vacuum motor on when you insert the hose and turns it off when you remove the hose. The diameter of the screw head is smaller than the original and all previous replacement sockets I've used, making it difficult to get the screw head in contact with the wire. Also, the length or body of the same screw is slightly shorter than the original outlets, meaning the threads can be…