ANVISION 3 Pack 100 250V Button Control Review

My case was to replace the floor dimmer on a quartz halide lamp where I replaced the heating tube with an LED, dimmable LED. I didn't need to dim the LED, and the old floor dimmer seemed to flicker when off, so I decided to replace it with a switch. This worked great in the app. A very nice design but should only be used by those who know how to handle basic household electrical parts. No instructions, but a small inspection makes the installation clear. It would be helpful if the recommended…

These lightweight switches should work just fine. Honestly I would give 5 stars if there were no instructions. So here is the installation procedure. Separate the top and bottom of the switch. The heart of the switch is a small rectangle that fits into the ground. Look closely at the heart of the switch and you'll see a slightly larger opening on either side. Most electrical wiring has two insulated wires that are often connected into one cable. Separate the two wires a few inches right where…

I like the idea of this product. And it works correctly. However, if there was a little more room to work inside, I would rate it five stars. You really have to use every microinch available to properly insert the wires and switch and fully close the case. I even considered cutting some of the insulation off the wire to make room. But I didn't. Security was more important to me than ease of installation. After much torment and twisting, I finally managed to install the switch and cables with…