APIELE 12Mm Momentary Push Button Switch Pre-Wired 150Mm High Round Head Aluminium Alloy 1NO 1 Normally Open With Ring Led Pack Of 2 (Red) Review

These switches are lightweight in the truest sense of the word. Each pin on the back is less than 1/8 inch and has a small hole, so you'll need to do some soldering quickly. The metal on the wire is pretty thin and soft, so I'd suggest some sort of discharger.

These illuminated snap action switches are just what I was looking for to control the exhaust ports to complement my XK8 console. Uses 2 (12mm / half inch) switches, one to open the cutouts and one to close them. The shifters were small enough to sit on the side of the sport mode switch without interfering with the shifter and other components in the cramped bay. The red ring around the button isn't too bright, but bright enough to be seen on a sunny day with the lid closed, but not too bright…

Media could not be loaded. So I needed the power switches to build my PC but the problem was they had to be 6ft from the actual motherboard. So I cut the pins off an old computer case, connected them to some long colorful jumpers I had laying around, and then attached them to these 12mm APIELE buttons. Two wires for the PC switch, two wires for the PC power light, two wires for the reset switch, and two wires for the hard drive activity light. Plugged it in and everything worked like clockwork.