🔘 APIELE 19mm Latching Push Button Switch 12V DC Angel Eye Halo Ring LED Metal with 0 Review

The product was fairly easy to install and worked great for several months. I installed this in the back of my truck near the back door. I could just open the gate, put my hand on the edge of the bed and press the button. This button connects to some LED pucks I installed under my bed rail. The switch wiring runs behind the rear wheel in a recess between the outside of the truck and the body wall. Water enters this space and the like. That's why I bought a waterproof switch. I made sure the…

So far so good. The LED wires are isolated from the switch contacts and the LED will glow at just 2.3V and less than 1mA in a lit room. I'm going to be using LED wires with a 3.3V microcontroller output, and that's what I would call ideal brightness at 3.3V. I don't see the full 1mA to 4V current. At 12V I see 7-8mA. The brightness in a daylight room doesn't change much after you raise the voltage above about 4V. At least in a room with daylight. Switch pins in different ways to show…

Good reliable switch. Requires a 3/4" mounting hole. You wouldn't want to go much further as the switch body isn't much larger than the threaded part. I hooked mine up to the LED lighting system under the hood of my car. So if you look at the picture, you can see that the red and blue wire goes to the positive wire of my LED lights, I found it easier to connect the wires together, then put a larger heat shrink tube over that, then another smaller heat shrink tube over the positive lead from the