Apparatus for manicure and pedicure Review

The apparatus (machine) for manicure and pedicure (20,000 rpm) is the most affordable machine for home use. The surface of the gray plastic case looks very practical and stylish. The presented portable and multifunctional device is equipped with a 12 W motor, which can easily cope with the correction of nails, correcting the shape of nails, removes cuticles, rough skin, calluses. It is recommended to use for preparing natural nails for modeling, as well as for building and correcting artificial nails. The maximum rotation speed of the cutter is 20,000 rpm. The device (machine) for manicure and pedicure (20000 rpm) is intended for the care of nails of hands and feet. The handle holder of the device is made of shock-resistant plastic, inside there is a metal clip for a cutter. The cutter enters the clamp tightly and is not fixed by anything. The machine is as simple as possible to use, equipped with a microprocessor-based speed controller, reverse and a convenient stand for the pen, which allows you to protect it from damage. The device is light, ergonomic, works from the mains. Complete set: power supply, pen, pen stand and a set of cutters of 6 multifunctional nozzles: Diamond nozzle for processing the edge of the nail; Diamond nozzle for grinding and fine grinding; Diamond nozzle for removing cuticles, calluses and rough skin; Diamond nozzle for cleaning under the nails ;Diamond tip for processing the edge of the nail;Diamond tip for the correction of artificial nails and finishing polishing. Characteristics: • Maximum number of revolutions 20000 • Block dimensions: 13 x 8.5 x 6 cm • Clamp type: Milling cutter collet • Reverse function - yes • Automatic overload protection - yes • Collet clamp diameter: 2.35 mm • Handle length: 14 cm • Block weight: 800 g Instruction: 1. Install the machine on a dry surface.2. Make sure that the wires, plug, socket are in good condition.3. Insert the desired cutter. To change the bit, turn the handle section clockwise (half a turn until it clicks) to open the collet, then insert the desired cutter and rotate the chuck in the opposite direction.4. Before plugging in the appliance, make sure that the switch is in the “OFF” mode to avoid injury caused by sudden start of operation.5. Set the speed switch to "0".6. Connect the machine to the network.7. Turn on the device using the power button.8. Before putting the handle back, set the speed to “0” and wait until the rotation of the cutter has completely stopped.9. To complete the work, set the rotation speed to "0", turn off the machine and disconnect from the mains. Precautions: 1. It is undesirable to include a milling cutter without a nozzle.2. Do not turn on the instrument until the handle collet is secured.3. Do not open the collet during operation.4. Avoid getting water into the device and avoid installing it on wet surfaces. Do not drop the machine and handle as this may cause the equipment to malfunction.