ArtResin Epoxy Resin Respirator Needed Crafting Review

I love this resin! I have always used the envirotex lite brand. I just filled out a few panels with photos and they seem to have turned out very well! There is something else in that. The most obvious is the smell. Almost odorless. Although it has the same consistency and mixing properties as envirotex, the final cured product appears smoother and glassier. I am preparing for my first art exhibition in the coming months using this resin! It's expensive but in line with other brands. I found the

I really like this resin. Especially longer durability to work with. This gives time to work on areas of detail that can trap air and I've found that when working with some silicone molds, frost is released on the outside where it makes contact with the mold, but this is actually a positive result for a clear colorless casting in high-performance molds. Small shapes come out crystal clear. The beauty of this resin is that it doesn't have a bad smell, lasts longer, and mixes and pours easily. I…

There's better. It is very thick and you may have to wait before pouring the resin into the mold as it will be full of bubbles, even if you mix slowly there may be air pockets. . I've used the whole gallon on a few projects and found that it's not a torch/heat gun. You should check your project from time to time as you may find burst bubbles or air pockets just like that. I've tried Frost 70* and Heat 98* the same. notes that it hardens faster in the mold when it's cold and takes about 2 days…

I was very pleased with this resin. I watched and read it for a year before I bought it. I got a girl and started a bunch of projects. I did what I normally do and didn't get good results. My coasters had holes in them and the silicone molds I've been using for a long time stuck to the resin in places. This ruined a couple of my mold and coaster projects. It really worked when wood was cast for these parts. I emailed customer service regarding this and they were unsure as to why this would be…

I bought 2 gallons of ArtResin at the end of June and received it in September (2.5 months) because it was sent to Armenia. Everything was in order. I used it on my first print (45cm x 30cm) and the results were impressive except for the dust. But it was my fault. A month later I solved the dust problem in the workshop and prepared another work (170cm x 60cm) to add resin. I was not at all satisfied with the result because of the millions of tiny bubbles. The product description says the…