🚗 Set of 4 Aukur Logo Projector Car Door LED Lights for Nissan - Enhancing Vehicle Entry Experience Review

This product is very easy to install and looks great on my Maxima. My only 2 complaints were that the product seems cheap and not the cleanest, but it was close enough. Overall I'm happy with the end result.

4 pack, in 2 bags of 2 in package. The projector is not mounted in a plastic bracket and needs to be slightly flexible to allow the pins to fit in the correct holes. the old one came out with no problem. You have to squeeze the electrical connector to pull it out. Then align the tabs on the new device with the bottom slots. Plug them in and they should light up. Hold your hand close to the new block and during the day you can see the logo.

I have a 2014 Nissan Altima and connoisseurs see the Altima everywhere. So I try to change it and make it different and unique in my own way. You need to make sure you pay attention when deploying them. The connections should be pushed down a little to allow them to go into the connector. Make sure that the connections do not go into the top two holes, but into the bottom two holes in the connector. You can also adjust the image by taking it out and rotating it if you've pasted it and it looks…

That's great! I didn't realize my '17 Maxima didn't have lights on the rear doors, so I only needed two of them. I now have two spares in case one stops working. Looks very nice after installation. I had to rotate the case 180 degrees to read the logos correctly for the person getting into the car. I also had to shave off some of the plastic door moldings to make them flush like the factory, but the plastic is flimsy and soft and never shows if you decide to go back to the original headlights…

I have a 2014 Titan and as I needed to replace the door lights I decided to use them. I had to flip the logo because it was upside down, no big deal but as you can see in the photos the light cap doesn't fit. It's like the back of the light is so thick it's pushing it out. I tried several ways to slide it into place but it wouldn't go in. I removed the lantern and put on the cap to make sure it fit. And yes, it fits. But as soon as I turn the light back on, it no longer comes on. I don't know…

Purchased for a 2004 Nissan Armada. The package and the product arrived in perfect condition and were delivered quickly. I don't trust the product constructively. The lens (with the Nissan logo) was not an integral part. You can remove it effortlessly (it falls out easily). The LED module was also only in the door lens and was too big to fit properly in the door. If I took out the module, the door lens would fit like the original; However, you will need to trim some of the plastic (Dremel tool,

So I started my lighting adventure. Some say it mounts straight, others say it mounts upside down, etc. These are tips I learned while installing them on my 2019 Nissan. Even if you haven't tried the installation yet, the advice will seem like nonsense. So if you're having trouble getting it to work, go back and read this and you'll understand what I'm talking about. Note. The plug has two pairs of tiny holes, don't put it in the wrong one. Your pins can be taller than your plugs for this to…