📦 Awclub Clear Distribution Protection 160mm x 120mm x 95mm Review

This is not a compensating comment. Good quality building materials, size suitable for switches. Mounting options are acceptable. Access window works correctly. The switch bracket needs strengthening, thicker aluminum with reinforced mounting points will suffice to secure the switches and/or facilitate safe insertion/removal. I recommend this product.

Not a heavy duty box but will fit anywhere that doesn't involve physical exertion. I'm a bit worried that the stress from the smaller knockouts might break the ring for the larger sizes, but I haven't really seen that. At first I thought the lid only opens 45 degrees due to the strong latch - push it further and it pops open a little over 90 degrees and stays there. Rock it up and down a few times to smooth out the latch. The mini PLC is fine as it is. Post subject: The open/reset lever on some

This is a great little project case if your project uses DIN rail devices or circuit breakers. extends beyond the visible window and allows for the installation of end anchors, low profile fuses or terminal blocks in this "enclosed" area. I used this for ground anchors and a fuse block before replacing the MCB with a device that protected the fuse when I found I had enough room. , for terminal blocks, as there are none here. Note that using the side piping holes will add clutter to this extra…