Header banner
Revain logoHome Page
πŸ”§ top-notch woodworking trim router bearing by bestgle logo

πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle Review

3

Β·

Very good

Revainrating 4.5 out of 5Β Β 
RatingΒ 
4.3
πŸͺš Router Bits, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle
img 2 attached to πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle
img 3 attached to πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle
img 4 attached to πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle

Description of πŸ”§ Top-notch Woodworking Trim Router Bearing by Bestgle

Made of 45 high-carbon steel and alloy, high-grade welding, stable quality and high efficiency. Ideal woodworking tool for cutting all composition materials, plywoods, hardwoods, and softwoods. 2pcs 1/2” shank Pattern Flush Trim Router Bit. Cutting Length: 1-1/2" and 1-1/32”, Cutting Diameter: both are 3/4", total length: 3-23/32” and 3-1/4”. This bit can be used with either a top or bottom template. Especially useful for template work when routing rounded or curvy wood with sensitive end-grains. The top and bottom bearings allow you to flip over the wood stock when you reach "up-grain" and rout that segment in a "down-grain" direction, maintaining uniform smoothness around the work-piece.

Reviews

Global ratings 3
  • 5
    1
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Good value for money. - Power tool parts and accessories

Good value for money. Moderately sharp. The bearings seem fine. Haven't used much but seem to be holding up their sharpness.

Pros
  • Ideal woodworking tool for cutting all composite materials, plywood, hardwood and softwood
Cons
  • No performance

Revainrating 4 out of 5

seems to cut very well!

I've only used both a few times, but both cut very smoothly, I slowed them down a bit though. We'll see how long they last, making sure they can't be sharpened too much, if at all.

Pros
  • Made of carbon steel and 45 alloy, high quality welds, stable quality and high efficiency
Cons
  • Expensive

Revainrating 5 out of 5

Most of them have woodworking cutters

I started making boards with corn holes and for the first 40 sets I made I used a 6 inch hole saw. Drilling 3/4" plywood was a strain on the chisel, the drill bit, and myself. I was told to get the router bit flush and route holes. I was able to make more boards in less time and get a better edge finish too. I used the longer cutter to flush 2 pieces of 3/4 inch plywood which has a unique design. The long cutter in my cobalt router had no problem cutting through the material. Heavy use

Pros
  • 2 pcs. 1/2" Flush Shank Milling Cutters. Cutting Length: 1-1/2" and 1-1/32", Cutting Diameter: Both 3/4", Overall Length: 3-23/32" and 3-1 /4"
Cons
  • Miscellaneous Miscellaneous