🔦 Super Bright LED Interior Light Kit for Toyota Tacoma 2016-2021 + License Plate Lights and Install Tool by BRISHINE Review

For the most part these lights match exactly, however one of the map lights didn't work even after I tried to reverse the polarity by rotating it 180 degrees. To make sure the circuit was working properly, I reinstalled the standard bulb and it worked, so the LED bulb wasn't glowing well. Could you please send me another LED headlight for my 2020 Toyota Tacoma. I was contacted by Revain and the supplier and they sent me a replacement lamp. Very quick reply. Additional update date, supplier…

Headlights seem to work great with much brighter output. (can't take her lightly). I ended up just removing the entire overhead console and installing it in the back. The overhead console is held in place by 4 plastic tabs/plugs (you can't see them) and detaches if you just pull the console down (it's scary and you think you'll break it, but it bounces up and down easily ). by pulling/pushing backwards, just grab a corner and drive around) - License plate light is hard to reach. You need to get

Removing the card backlight is a bit difficult. I used a strip of duct tape, wrapped it around the stock card lights, and then pulled it vertically. I blew a 7.5A fuse when installing the dome light :P During installation the headlights were off and the battery was disconnected. When turned on, all the lights in the cabin went out and would not come on. Replacing the fuse is easy. There is white plastic trim on the left side of the driver's footwell. Simply remove them, refer to the diagram…