BZONE 2-Pin LED Strip Connectors 10-Pack with 16.4FT Extension 🔌 Cable for 10mm Wide Waterproof Single-Color LED Strip Lights, Quick Strip-to-Wire Connection Review

They don't hold led strips I have them 8mm but when I close them it doesn't do anything, apparently they aren't thick enough I don't know if they're fatter or not, i've never seen them fatter, they're useless

One star is too many. Don't waste time and just buy a soldering iron and do it right. Waste of time and all you get from it is disappointment. Half of them broke and didn't latch properly, leaving you struggling to keep the light working. Do not buy

The most difficult plug to use. I spent hours taking these clips apart to try and align the pins on my bands. You don't just click and go. Not only do they not match the positive and negative sides of the light strips, they also don't press them hard enough to pierce the strip. wasted money and time.

I bought these for an RV project I was doing. not only do they work amazingly! They are really easy to use and install in seconds with no stripping or soldering. I wish I had known this years ago when I first started converting LEDs, it would have made life a lot easier for indoor installers!

I have had several different magnetic cables since they became available and have been disappointed with them so far. They either had weak magnets or just didn't have a very good connection when plugged in. On the other hand, these BZONE cables work as advertised. The magnets are strong and the rotating connectors make my devices easy to use once plugged in. I will definitely buy them again.

Very bad design 42 years in telecom I've seen all kinds of connections. The side of the tape is poking through from underneath and not making proper contact with the gasket. You can have continuity, but it's not reliable (fails under load). The wire side uses insulation bias which is usually reliable, but the design does not keep the wire in alignment when crimping the connector. If you think this is like Scotchlock connections, then it isn't. Instead I soldered the wires. Would return them but

These connectors are junk. I bought a model that works with waterproof IP65 LED strip, at least that's what the description says. The side of the clip that takes the wires works fine, the side that takes the LED strip doesn't. The electrical connection is not strong and the slightest flex or wiggle will break the circuit. I created 3 longitudinal lintels that needed a few turns and I'm glad I tested them BEFORE attaching everything to the bottom of my cabinets. Just the lightest touch and…

I liked how the cable connection was implemented. This would get my 5 stars if the review had a separate category. However, the side of the LED strip is poorly designed. It pierces the contact plates on the strip and creates a galvanic connection. This approach cannot physically provide a good contact area between the strip and the copper conductors of the connector. This gives good structural strength but no conductivity. Do not use this connector if you have a high current circuit. The…