🔌 CableCreation 2-Pack Fast Charging Short Micro USB Cable, Triple Shielded Fast Charger Cable, Compatible with Roku Streaming TV Stick, PS4, Power Pack, Android Phone, 0.5 ft - Black Review

This was the perfect cable for my desktop charging station until it stopped working. It was delivered on July 22, 2018 and ceased operations in mid-September. Although it wasn't very expensive, I expected to live longer than 2 months.

I bought this line at the end of November 2017. I decided it was worth a try for $5. I used the cord on an Anker power supply and it worked fine until early March 2018. I probably used the cable about a dozen times before it stopped working as intended. Now that will work, but the cable needs to be bent at the right angle, and if it moves even a little there will be no power. Unfortunately, this cable is the perfect length for a power supply.

I bought these cables to pair with my Actiontec ScreenBeam mini 2. It did not work. The Mini 2 wouldn't turn on, leading me to believe it wasn't generating enough power from the TV. I used a different micro USB and was able to use it on my TV for a little over 2 years with no problems. Then I got this pair. The only reason I'm rating it is because the quality of the braided line was good and I could probably use it for something else, but it wasn't good for the intended pairing.

I take a lot of devices with me, especially when I travel, but I don't have the patience to fiddle with a bunch of cables. Insert small cords: Just enough to charge the device, it doesn't take long for them to get tangled and dirty. This little guy is perfect for that. It's long enough to reach from any charger, especially the one on your desk, but won't get in the way in your pocket. It is well made, feels good in the hand and fits well in my pocket. The perfect solution, especially since you…

But unfortunately the plug is too small and therefore doesn't stay connected to my device. I have several other microUSB cables that I have no problem using on this device. I wanted this cable because the distance I need is only about 2 inches and I was using a standard 24" or 36" cable. They connect fine so I know it's not my device. When I plug in the microUSB connector, after a few seconds it just pops off and disconnects. Too cheap to even try to return as the cost of returning the ship is…

I got this cable to connect my Raspberry Pi Octoprint server to my 3D printer. I installed the RPI right next to the micro USB port on the printer and this cable is the perfect length. The cable makes a very good impression. It will be plugged in all the time, so I'm not too worried about durability issues. Just a note: when connecting your Raspberry Pi to your 3D printer, you must put a piece of electrical tape over the 5V pin on the USB-A side of the cable, otherwise the RPI will power the 3D

So, a month later, when I put the charger and phone in my bag to take to work (17,000 steps a day on average), I noticed that the spot where the braid in entering the plug began to wear out and the material of the black thread separated from the white under the scabbard, no. The cable is not open, the charging cable is still working and can be charged at high speed. The size is perfect for folding with the charger on one side and the phone on the other and in my pocket. I have two cables from…