🏕️ Effortlessly Remove Tent Stakes with Camco 51058 Tent Stake Puller Review

When I got it it didn't seem like much but it works great. I hate carrying around a hammer to try and get the tent out of the canopy and dog fence, but it makes it quite a bit easier, lighter, and easier to store and take with you on the go.

The price was cheap so I decided to try one of these on our trip to the beach this summer. We bought a new tent for our son and some of the stake points were stretchy so it wouldn't be safe to just grab the "rope" and pull to release the stake. The bars we used were yellow 9 inch. They have a nice hole in the "head" so I figured this puller would slide right in and you could pull them out. But the hole is too small (or the puller is too big) so it didn't work. I've found that when you push it…

Bought these to replace the thin metal rods that came with the beach cover. These stakes are very strong and will stay in place until you pull them out to pack. Suitable for use on sand and grass surfaces. The bright yellow color makes it visible to avoid trip hazards and the plastic material will not rust. Comes with 6 inserts. Easy cleaning by rinsing with water. Can be used without a rubber mallet if the ground is not very hard.

I usually camp at a certain campsite with tent gravel pads and these are the best pegs I have used for this type of ground have ground. They stay in place compared to round metal stakes. I haven't had to use them on hard, rocky ground, so I can't say how well they will work. I have both a 9" and a 12" and would highly recommend them for the application I mentioned.

The price was low so I decided to try one of these on our trip to the beach this summer. We bought a new tent for our son and some of the stake points were stretchy so it wouldn't be safe to just grab the "rope" and pull to remove the stake. The bars we used were yellow 9 inch. They have a nice hole in the "head" so I figured this puller would slide right in and let you pull them out. But the hole is too small (or the puller is too big) so it didn't work. I found that there is a small…