🚦 Syneticusa 7443 Error Free Canbus Ready Red LED Brake Parking Tail Stop Turn Signal Light Bulbs: No Hyper Flash, All-in-One Solution with Built-In Resistors and DRL Parking Lamp Review

These bulbs produce a rich red color and are a good upgrade for my Tacoma's stock taillight assembly. I had no problems with Hyperflare.

Revain says the light bulbs don't fit in the LT trim, but they do. Much brighter than standard bulbs and no hyper flash. Very easy to install.

Plug and Play worked great on my '14 Silverado and I loved being able to rotate the bulb so the light hits the right spot in the taillight housing

Just installed today. So far I'm super satisfied. These things are ridiculously bright compared to factory incandescent bulbs. You can see the LED in the picture on the left and the standard on the right. This was included with 4 paths. If someone behind me does not see these lights, then they are blind. Installation was easy, the hardest part was figuring out how to install the resistors. Hope they last long. I will update if anything changes.

I like the brightness of the LED lamps but they should waterproof the connectors better. The most common lamp failure is that water/moisture corrodes the connection between the series connector and the lamp connector. Also the resistor housing has the same problem due to the lack of gaskets to prevent water from entering the resistor housing. Lights are a great solution if they solve the above problems.

I bought two sets of these bulbs for my 2018 GMC Sierra 2500 HD to power the red taillights. Works perfectly and was easy to install. They take up extra space in the taillight assembly due to the resistors placed between the connector and the bulb, but the GMC has plenty of room and they fit perfectly. I now have all the LEDs on the back of the truck and have purchased amber blocks for the front turn signals to be installed next week (by the pros as I can't get to my truck's access ports).

Updated Review (September 2020): Stay away from these lights if you love your car. I have rear turn signal warning and I'm glad I have it. As soon as I took my taillight out, over time the resistor literally melted all my wires and melted the hole in my taillight. Rusted my braid too. Worst mistake buying this product and I will NEVER buy this brand again. Old review (February 2020): This light will light up the night. The taillight is twice as bright as my standard halogen bulbs. As soon as…

Installed on Tacoma TRD 2020 OR. The quality seems to be good. Installation was pretty easy, but they don't provide instructions. Just remember that the resistor needs to be attached in some way. Mine didn't have a mounting hole, but luckily I was able to tie the wires so the resistor was snug against the body brace next to the taillight. I wouldn't let the plastic tie come into contact with the resistor. Contrary to what is indicated in the characteristic curves, the resistor heats up. I've…

This is a good light, my OEM taillight went out after 80,000 miles and I got it as a replacement. It is very well made and fits my 2016 Chevy Malibu LT perfectly. It's easy to install, but it's not the same as the original. You need to plug it into an outlet after taking out the old one then you have a flashlight and a resistor with a decent length of wire wrapped in silicone. This one doesn't roll or lock up like the old one because it has soft silicone around it. You can just snap it into…