Enhance Your Braking Performance with Carlson Quality Front and Rear Disc Brake Caliper Guide Pin Boot Kit - Model 16078 Review

They are pressed. and a light hammer. Tip: I installed them by tapping them with a 20mm socket after "screwing" the head over the slider so as not to damage the rubber with the bushing when using a light hammer knock on it.

At first I didn't know where to get replacement parts for my brakes. When I first saw this part I didn't know where it was going. But after getting on the brakes, I discovered a very important part of my brake upgrade job, some of it won't get done until the weather hits. It is necessary to do the work with all the new parts that can save their lives on the road.

My wife ordered this for her Lexus IS250 but I used it on my 1996 Toyota Corona Premio. A211-aepek frame: At211-0027190 and it fits perfectly. Folks, you can damage your boots if you forget to remove the piece of metal that remains at the end of the caliper. There is no need to use fire. Simply place the end of a flathead screwdriver on the outside edge of the slot and gently tap the edge. An old spiritual anther pops out. Then you can install the new one. I fitted the new boot rubber into the…