💡 Efficient Warm White LED Panel Ceiling Light Fixture - 18w 5730 SMD Circle Annular Round Replacement Board Bulb Review

Light ring works quite well. Not as bright as I was hoping, but really good. This eliminates the need to replace the entire fixture and the price is definitely good. My light is large enough to fit a ring so the individual LEDs are visible over the edge. glass dome. Pretty good value for money

Easy to assemble. Light ring and LED driver box. Uses magnets to attach to the bottom of the mount so you don't have to drill holes. Fits perfectly into an existing 12" diameter fluorescent light fixture. The old lamp cover blocks the light a bit, but the cover is old and faded.

I had a round fluorescent/light that extinguished in the base that I use to light my sculpture. I chose LEDs because I wanted a brighter, whiter light. This light fits perfectly! It was easy to install, the light is nice (almost too bright but I like it). And it was cheaper than many others I've seen at Revain. I highly recommend!

I used this to upgrade an existing old low wattage warm LED light to a much brighter and whiter light. The magnetic mount on the existing mount was a great solution for a quick and easy installation of a new ring. The newer LED driver was also less wattage (18W) than my old one which was 22W and less LUX. Installation time: 30 minutes or less.

We received this fixture to replace an old round fluorescent bulb and ballast that was making an annoying buzzing noise. It arrived with no instructions, but luckily it was fairly easy to install (we connected red to black and blue to white). In fact, we didn't even use the magnets that came with it, but adapted them to the metal brackets that hold the fluorescent tube. The light is quite bright, much brighter than our old fluorescent tube, but very white, almost bluish. Overall, however, I am…

I used these to replace 12" round FC12T9 fluorescent bulbs in 2 ceiling lights each 1600 lumens. They entered very easily and quickly. I chose 3000 K (warm white) for our bedroom, since I only installed it today, I can't say anything about the durability of the LEDs and the driver. with a Phillips screwdriver. After making sure the power is off, cut the AC wires going to the CLF ballast as close to the ballast as possible, stripping the ends about 1/2 of the way. 4". o Attach the LED ring and…