Charge controller DELTA Battery PWM 2410 Review

PWM solar charge controller Delta PWM 2410 is designed for systems on - 12/24 V. With a charge current of up to 10 A. and a battery voltage of 12/24 V. The maximum power of solar panels is 2x100 W. Benefits1. Automatic recognition of voltage in the 12V/24V system.2. An improved three-stage battery charging algorithm is used. Periodically or in the event of a deep discharge, an equalizing charge of the battery is switched on, which effectively slows down the sulfation process and prevents the occurrence of uneven state of the battery cells, thereby prolonging its service life.3. Availability of USB connector.4. When using temperature compensation, charge parameters change automatically.5. A wide range of operating modes allows the controller to be used with any type of load.6. The controller provides protection against overcharging, deep discharge, overload and short circuit.7. Advanced switching method provides soft start of capacitive loads.8. The controller is equipped with a graphic LCD screen, controlled by a button.9. Intuitive interface.10. Industrial design provides the controller with reliable operation under any difficult environmental conditions.11. Lightning protectionFive load modes1. Light control (0): When the direct sunlight fails and the light intensity falls below the threshold value, the controller switches on the load after a minute delay (settable). When sunlight appears, and its intensity exceeds the threshold value, the controller, after a minute delay, turns off the work of the load.2. Light control + time control (from 1 to 14): The load is turned on in the same way as the "Light control" mode. Load operation is switched off automatically after the set time period (set from 1 to 14 hours).3. Manual mode (15): In this mode, the user independently turns on and off the load by pressing a button. Time of day does not matter.4. Debug mode (16): If there is a light signal and the voltage on the solar modules is 6V, the load will be disconnected. In the absence of a light signal and voltage on the 5V modules, the load will be switched on. This mode allows you to quickly check the correctness of the system installation and carry out troubleshooting.5. Normally on (17): The load is constantly energized