🏍️ LA Choppers LA-7361-16B 1.25-Inch Twin Peaks Touring Handlebar, Black, 16 Inches Review

This 12" handlebar looks and feels fantastic. Precisely. I installed them myself on my 2019 Street Glide Special. I didn't have to dismantle any wire connections with the connector. Soap for washing dishes. Pull and push on the standard wiring. It took me about 3-4 hours to do this. I had never done this before and was in no rush. The only problem I had was losing power to the entire dash and panel controls and found the 5 amp fuse had blown. Before starting this work, I suggest removing the…

I haven't finished installing it yet but I was expecting an easy install but it didn't happen. intend to lay the control line outdoors, send it back! I didn't know the difference so I started installing them and had to figure out how to get them working. Push bars require you to run internal control cables and on my 2011 FLHTK with heated grips I'm on day four of the install. . Hope to be finished in the next few days. I had to grind down the through holes significantly and sanded the chrome…

These great handlebars installed with expected difficulty and I didn't have to replace the stock clutch cable or brake line. However, I lengthened my wires by six inches to make installation easier. I don't know if the rods will fit standard length cables, but given how much "extra" there was (or wasn't) at the end of the job, you might want to simplify the installation. and unload the connections. Pulling the wires through the bars, especially on the throttle side, was a bit of a chore, but…

The bars look great assembled. Wires, as others have mentioned, are a pain. I installed these 14" Buddy bars on a 2014 CVO Limited with stock clutch tubes and brakes. The only downside, apart from the cables, is that the handlebars don't fit my bike. Both sides have recesses for handles. They can only move in one direction, but on the throttle side, this turns the crank a quarter turn. So if you have black cranks, like the Limited, you'll never notice, but if you have CVO cranks, like me, they…

I was replacing the stock handlebars on my 2016 Ultra Limited. I found online that the cables would work backwards and I didn't want to change the clutch/front brake lines. The installation wasn't bad to do with basic hand tools and some wrench connections, this youtube video - the install was on a 2014 strret glide without heated grips but helps to see the process it took about 30 minutes to do the fairing and breaking the bars, and probably an hour to strip the wiring and fish out new bars.I…