🚲 Enhance Your Ride with V-factor Foot Shift Pegs - Perfect for All Models! Review

Fit 1" extensions to my floorboards on my 2015 Ultralimit, I need to move the switch pin a bit to fit widened floorboards, this switch pin does the job Job done, good quality, looks ok, The screw is a bit long but that's ok, very satisfied, takes less than 5 minutes to install and the price is good

Included is a picture of a standard pen versus an installed ISO pen. With this binding, switching is much easier. The only downside is the rubber rings are loose and tend to come loose which happened to the outer ring and seems to match this design/pen. Stick them on before use and this wand is gold (actually chrome plated). Highly recommended.

requires a longer shift pin than standard size. This is almost twice the size of the stock Harley shift knob on my Dyna superboot. Easy to install with the included Alans key. add a drop of blue fixative and you're done. ONLY minus, the stock is about 1/4 inch longer so the stock sticks out the back of the arm. I have the mother on the back. don't worry about it. If so, can you shorten it a bit?

When I ordered the footpegs the description said they only come with one pin so I was already pissed I had to buy another one. So I buy another one and when I received it the quality control is poor, the o-rings don't match or don't match. I have two footpegs and if you have OCD you can clearly see that there is a gap between the o-rings. Not the same. I don't understand how this could happen as it is a process.

So it was so cheap and I really needed a wider switch pin because the pin was so short. Tried a pedal instead of a pin but was actually worse. Thought I'd give it a try as it's not much. Let me tell you this is the real thing. As good as anything I've ever bought from Harley. This beauty is nearly 4 inches long, and if you can find a washer small enough to fit the bolt, you won't have extra threads sticking out through the back of the shifter. Glue the rubber bands around the pen and they will…

I have a wider foot pedal with heel peg on the Dyna Wide Glide 06 which made it a little difficult to get my toe under the stock shifter peg as it had worn out. on the right side, aligned with where the standard footpad used to be. I installed this replacement with no rush and was able to keep the retractable foot pedal support and now I can slide my foot under almost the entire shift peg. No more skipped transmissions. A plus. The threads on the new widened derailleur pin allow you to roll the

Fits 2015 Ultra Classic with full size equivalent on shifter. I have a size 13 boot and always felt like I had to come along to attach/find the derailleur pin. It was annoying and uncomfortable so I decided to give it a try. Now I no longer have a problem finding the pen and I feel completely at ease. I read some reviews that mentioned some of the rubber rings coming off. So far in the last 5 months I haven't had any problems with them when installed directly from the package. I suspect it…

Exactly what I was looking for. It is approximately 1 1/2 inches longer than a standard toe cap. Now I don't have to try to tip my foot inward to find the footboard. It was installed on the 2017 Harley Davidson Ultra Limited. several turns before using the power wrench to avoid cross-threading. You can also add some screw lock. The screw is slightly longer than stock and goes through the shifter about 1/4". A simple fix for those who object to the edge. Install pin, mark excess threads with a…