🚗 Cllena 5-in-1 Car Charger Panel with Dual USB Sockets, LED Voltmeter, Cigarette Lighter Adapter, Toggle Switch – Blue Review

I am using this on a battery pack for an astronomical tripod. I didn't need most of the extras with these "strong tanks". The case I used made the wire a little tight with the size of battery I had. Everything works fine, I want to know the voltage, give me a hint if it drops.

Installed in a Dodge Dakota Club Cab. Easy installation and great looks. You need to buy some sweaters or make your own. I purchased a jumper kit for a QUNQI STAR 5-pin rocker switch (male/female) (5-pin, 6 sets) and configured it appropriately to connect to the truck's 12-volt system.

How big and has everything I need to make a portable power bank to take to sporting events to run three 12v electric blankets, that consume a maximum of 50 watts. I am making a power supply using two 12v-20v LiFePo4 batteries connected in parallel which should give me 512w. I will be using 2 Eco Worthy 12 volt 20Ah LiFePo4 batteries which I also got from Revain which weigh 4.85lbs each. The power bank also has 2 USB ports for charging phones.

I saw a review that said it was a German product. NO! The packaging clearly says "Made in China" and you can tell. The included connectors are not what you want, but they should be "container" style. The device itself seems pretty well made, although I have reservations about the switch. It's very thin and the bracket to hold it in place is tiny. I think it's overpriced considering everything, especially having to find other connectors to install it.

I used 14 gauge black (negative) and red (positive) wire from this unit to the fuse box. I had to cut the center loop of each wire going to the connector (the connector comes with this item except for wires) and then tape the wires from the center of the loop to complete the circuits. The 3-pin power switch works as follows: #1 Flip the item backwards. Connect the POSITIVE wire from the BATTERY to the 1st connector on the left. (This positive wire will not be attached to any other wire in the…

Got this as part of my dad's birthday present to allow him to race his new boat. And he loves it! You can change the layout to your liking, but be careful when plugging it in. I actually removed one of the 12v outlets and replaced it with an iPod adapter accessory from Radios. It's hard to tell how complex the setup is. It wasn't difficult for me at all. But I'm comfortable with power tools to make the hole needed for installation. Just make sure you measure, then measure again, then double…

Fits the 12v sockets in my van. I wanted another Duell 3.0 USB plug and they all came with gauges so I used the one they ended up going with from the same company to replace the gauge plug. I was hoping it would fit and it was close. The panel and included connectors are slightly flat on both sides to keep the connector straight in the panel. Being aluminum, it was easy enough to sand down with a small rotary file in my drill press (as was the separate 3.0 connector). Also, the switch backlight