Header banner
Revain logoHome Page
πŸ”Œ comidox ws2812 rgb light strip driver board - arduino compatible with 8 leds and 8 channels - built-in full color-driven development board - black (2pcs) logo

πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS) Review

3

Β·

Very good

Revainrating 4.5 out of 5Β Β 
RatingΒ 
4.7
πŸ–₯️. Single Board Computers, πŸ’» Computer Components

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS)
img 2 attached to πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS)
img 3 attached to πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS)
img 4 attached to πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS)

Description of πŸ”Œ Comidox WS2812 RGB Light Strip Driver Board - Arduino Compatible with 8 LEDs and 8 Channels - Built-in Full Color-Driven Development Board - Black (2PCS)

5050 high-brightness LED, built-in control chip, only need one IO port to control multiple LEDs. High-brightness LED, high brightness consistency. Chip built-in shaping circuit, signal distortion will not accumulate, stable display. There are connection interfaces at both ends, which can be directly plugged in. The serial connection interface can complete data reception and decoding through one signal line. Three primary colors 256 levels of brightness adjustment, 160,000 color true color display effect, scanning frequency is not less than 400Hz / S. Data transmission and transmission speed up to 800Kbps. When the refresh rate is 30 frames/second, the number of consecutive steps in the low-speed cascade mode is not less than 512 points.

Reviews

Global ratings 3
  • 5
    2
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Good strips, work well

I like these strips for WS2812 simple indicator LEDs. I had no trouble connecting several of these and ran them at different intensities for several days with no issues. PCB solder pads Ground, VCC, DataIn on one end and Ground, VCC, DataOut on the other end. There is also another ground connection at each end in the form of a 4th solder pad. Each strip has two mounting holes between some SMD resistors, with enough room for a screw head - I suggest nylon to be on the safe side. 3.3v is required

Pros
  • Computer Components
Cons
  • Ratio Set

Revainrating 5 out of 5

Great little sticks

Very different from other non-pixel sticks I've bought. This one is a bit longer and the entrances are on the opposite side. In addition, the color of the pixels is very unique. Do not try to mix/match it with other sticks. I did just that and ended up having to buy another set to complete my project.

Pros
  • Electronics
Cons
  • No insurance

Revainrating 5 out of 5

Great little sticks

Very different from other Neopixel sticks I've bought. This one is a bit longer and the entrances are on the opposite side. In addition, the color of the pixels is very unique. Do not try to mix/match it with other sticks. I did just that and ended up having to buy another set to complete my project.

Pros
  • Computers and accessories
Cons
  • Minor issues