18-Inch Corrugated Stainless Steel Flexible Water Line with 1-Inch Female Threaded NPT Connector 💧 - Ideal for Water Softeners Filters System Supply - Heavy Duty Bendable Flex Pipe Connections Review

So far so good, no leaks. Good inner diameter and 1 inch thread. Ideal for softening water but not too restrictive. Many Thanks.

Easy install on a piece of flex pipe sounded great but the leak made it less than pleasant. I removed it and cut off more of the plex line and tried again. The same story. One of the lines worked great, the other didn't.

Not satisfied, there is a dent on one end. This was not due to damage in transit. You can see it was made with some kind of press during production. I had to use it anyway because I needed water. I'm afraid it might fail so I'll be replacing it soon.

We used two of these flexible water fittings to install a water softener in our new home. 1" male connectors solvent welded to a 1" CVPC loop in a garage. I was able to move the fabric softener against the wall to make it flush. It will be easy to separate if necessary.

They work great and it was great to have flexibility with the installation. Did a quick install. They will be used outdoors in humid environments so I'm hoping the stainless steel aspect will hold up. To date they have been installed for about 2 months. Let's see how they behave over time.

This makes the very complicated connection of the water softener easier. It's difficult to bond plasticizers to copper or plastic, unless it's PEX, without stressing the plastic-plasticizer bond. This can lead to failure under load and serious leakage. They allow you to make complex bends and turns, connect a plasticizer and practically do not load the connections. Although it's a bit pricey, the complexity and risk of other routes make it worth it. However, check your local codes to make sure…

I bought four of these to install an entire home water filtration system and booster pump in a small space. I wanted the ability to easily adjust items during this setup and easily remove/replace items as needed. They cost a little more than I'd like, but they're worth it for getting the access I need. You need to be fairly straight at the plug or it will leak, although it's pretty obvious. They are not very easy to manipulate as they are 1 inch lines. It's easy enough for me to put them in and