Header banner
Revain logoHome Page
💍 silver coupling connector accessory fittings logo

💍 Silver Coupling Connector Accessory Fittings Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.3
🔌 Couplings, Collars & Universal Joiners, 🔩 Power Transmission Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to 💍 Silver Coupling Connector Accessory Fittings
img 2 attached to 💍 Silver Coupling Connector Accessory Fittings
img 3 attached to 💍 Silver Coupling Connector Accessory Fittings
img 4 attached to 💍 Silver Coupling Connector Accessory Fittings

Description of 💍 Silver Coupling Connector Accessory Fittings

【Durable Material】 Ancirs coupling connector is made of fine plating steel, heat and electroplated process make it sturdiness and insulation, striking shaft more stable and easy for installment and replacement. 【Standard Specification】Inner Diameter: 8mm. Cylinder Outer Diameter: 10mm. Cylinder Height: 10mm. Base Diameter: 32mm. Base Height: 2mm. 【Wide Range of Use】Ancirs flange coupler is produced based on International Flange Standard, widely used in model shaft connection, perfect accessories for RC Model motor. 【Package Include】Ancirs flange coupler is packaged with 2 pack 8mm Flange Shaft Coupling + 2x M3 Mini Hex Wrench + 4 x M3 Fastening Screw.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 3 out of 5

Unthreaded flange holes

seems substantial enough for my purposes, but I was a little annoyed when I noticed the holes were unthreaded. It's not that hard to carve them yourself if you don't have clearance for the nut, but still

Pros
  • Standard specification
Cons
  • The long lead time

Revainrating 5 out of 5

They are very heavy.

I like the strength of these flanges. In any case, they are too heavy. If you wanted to maximize their strength, you would need to put a real screw in the axle, not small set screws.

Pros
  • Strong material
Cons
  • So far so good

I have the 8mm version and the 8mm shaft. When the manufacturer drilled and tapped threaded holes for the set screws (i.e. two threaded holes to connect the flange to the shaft plane that fitted therein, not four holes on the flange rim), they introduced burrs into the hole that they forgot to clean . The burrs prevent the flange from sliding over the burr onto the shaft. This may be a one off issue (everyone else seems happy) but both flanges I received are useless without modification. Filing

Pros
  • Wide range of use
Cons
  • Discontinued