🪟 d-c-fix Decorative Window Film Milky Privacy Sticker | Removable | 17.7'' x 59'' Review

I didn't even know this existed until I had to replace my front door and mentioned to a friend that I wasn't looking forward to the window freezing (clutter, smoke, etc.). He recommended it and I'm so glad he did! Super easy assembly and cleaning. FYI, I didn't have a squeegee but I used a large plastic spatula and it worked great!

This product is terrible! I followed the instructions on the screen: clean windows, wet windows, apply. I had to reset it twice in less than 24 hours. What a huge waste of money! I ordered another roll before realizing what a crappy product this is so now I wasted my money on 3 rolls. If it falls off again in the next few hours it will go straight into the bin and I'll try to find a decent quality replacement.

Installation was fairly easy but sometimes the edges would come loose and I had to re-wet and reapply the edges. I'm glad you can apply and reapply otherwise I would have wasted a lot of time. The foil has been there for two weeks. On installation, I agree with other people. Thoroughly clean and moisten the glass, apply a rough cut of the film, cut with a razor blade and remove the residue with a squeegee. Works great on my shower window and adds some much needed privacy. See attached picture.

This product looks great and is very easy to install. Simply cut out and apply to a damp, clean window, done. The instructions say to use a squeegee to smooth out the creases, but I used my hand and then a ruler and it worked great. The instructions also say to cut the film to the exact size of the window, but I cut the film longer on the sides and then used a razor to trim the excess off the window. The film cuts easily and cleanly so removing excess from the window was very easy. All you need

First time with this product. It is completely non-sticky on its own, you need to use water to make it stick to the glass. I was a little apprehensive at first but so far everything is working great and no blisters. Let's see how it reacts when it gets cold and condensation forms, it might not work that well but for now it's cool. I bought another product which is sticky on its own and I have to say I'm not very happy with the end result (lots of bubbles, sticks to itself, harder to remove)…

Edit: I am changing my rating to 4 stars after ordering another roll and doing it again. Installation steps: 1. Clean the window. Use razor blades to scrape off anything that doesn't come off.2. Cut a section near the size you need.3. Spray the application solution on the window.4. Remove the protective film.5. Apply snapping to the window. There will be "bubbles" of grout and the edges will not line up, but you will trim the edges. 6. Use a squeegee or similar object to press the handle…

I bought this along with window film installation spray. It was about $4. I also had a squeegee and box cutter handy. I carefully cleaned the windows and cut the foil with scissors. The backing paper has grid lines so it was easy enough. I didn't measure - just looked at it because I knew I would cut it to the exact size once it was on the jar. I had two pieces of glass to coat, so I basically did everything twice. With the first one I sprayed a large amount of solution onto the glass, peeled…