📦 Transparent Gloss Acrylic Case Enclosure for Arduino UNO R3 - DAOKI Uno R3 Computer Box Compatible Review

I would give five stars if instructions were included. Not contrary to the product description. As others have said, it's a bit of a chore and also a bit of a puzzle, but once you do it's pretty good for protecting your board. I added some little rubber feet on the bottom and now it doesn't slide as much as before. My biggest complaint, aside from the installation, is that there is no spacer for the screws that touch the top of the board. I would use my own but the screws provided are barely…

I am very disappointed in this box. First of all, one of the nuts for the three screws broke off when it was used for the first time. Second, the nuts will not hold without excessive tension. Third, the corners started cracking even though I didn't tighten the nuts enough to hold them. I even tried putting Loctite on these threads and they still wouldn't hold. Aggravating!

1) The protective paper on the plastic was difficult to remove. Peeling off the paper on the panel around the connectors broke the panel. 2) One of the PCB gaskets was missing. 3) The hardware is VERY small. 4) Assembly took over 30 minutes. Arduino with some ESD protection. That's why I bought it.

It took me some time to realize that it had to be mounted upside down. The rest was exactly as stated. All devices were correct. There were even additional details. After assembly it turned out to be a good solid case. Now I don't have to worry about damaging the board. You cannot attach other boards to the main board as it is covered. To access the reset pin you need to use something narrow, e.g. B. a pen, since the recess above the button is small.