DB Electrical SMU9102 Kawasaki Quadrunner Review

I've had this kit on my Honda for about 6 months and it's still working. The only thing I would like to point out is that getting the brass bushing out of the case is very difficult and it took some ingenuity to get it out. When pressing in a new one, do not push in all the way. Only push in far enough for the socket to be flush with the housing from above.

fits 1999 Honda 300 Fourtrax / worked great. The reviews show that you basically need o-rings and a brush assembly. Please everything is fixed. better reviews than a newbie so I chose this route instead.

. I installed this in the starter motor on my 2008 Kawasaki Brute Force 650. It's been a few months and it's working fine. Стартер и набор щеток для Kawasaki Prairie 400 имеют те же номера деталей OEM, что и мой Brute force 650. Я думаю, что когда я первоначально искал это, я искал Prairie 400, потому что в нем не было Brute Force 650. Но я сделал That. Search the Kawasaki website for OEM part numbers. That works great.

Starter spins like a champ again. This kit includes bushings instead of bearings and if necessary special tools are required to extract these bearings and install their bushings. apply a temporary lubricant and grind and grind the contact surfaces on the armature. Inspect the armature to ensure all windings are covered, magnets are not cracked, clean oil from inside if sealing failed. You'll need to remove the smaller side cover and remove the gears to pull this starter, keep them clean and…

. It's been a few months and it's working fine. Стартер и набор щеток для Kawasaki Prairie 400 имеют те же номера деталей OEM, что и мой Brute force 650. Я думаю, что когда я первоначально искал это, я искал Prairie 400, потому что в нем не было Brute Force 650. Но я сделал That. Search the Kawasaki website for OEM part numbers. That works great.

no more kickstarters! I bought this to convert a starter on a 96.300 Fourtrax. It's a complete makeover (everything you need). This is the second starter I've rebuilt, the first was a lawn mower starter which was a bit simpler. But the whole process took about 30 minutes. To do this, the starter is switched off, reassembled and switched on again. There are several videos on YouTube that show you how to restore it if you are unsure. I did this. I am now about 3 months old and now everything is…

Starter starts like a champ again. This kit includes bushings instead of bearings and if necessary special tools are required to extract these bearings and install their bushings. I reused my bearings and added some high temp grease. to them and also grind the smooth surfaces of the contact area on the anchor. Inspect the armature to ensure all windings are covered, magnets are not cracked, clean oil from inside if sealing failed. You need to remove the smaller side cover and remove the gears…