🔥 Denso 2344330 Air-Fuel Ratio Oxygen Sensor Review

Easy to install. Directly connected. This is the factory original equipment. So far it has worked without any problems. highlighted.

Works great easy to install fits my miata mx5. Removed the old and reinstalled in just 20 minutes. Would definitely buy another one from Revain.

This is a direct OEM replacement, however one of the two small posts was installed incorrectly and upside down. It was easy enough to fix, but it cost them a star.

Straight fit. Same block as the original. I had to replace one of the straps with the original one to keep the wire from rubbing against the frame. Very easy to apply, even comes with an anti-size - be sure to use, just don't over use.

What more can I say? Fits and works perfectly. I was lucky, I paid about $80, shortly after that the price went up significantly. Highly recommend instead of splicing a universal sensor.

I ordered this to replace my 02 bottom sensor in my 2002 Miata. It is ideal for OEM part replacement. No splices - connects directly to the connector under the driver's seat. I also ordered Revain's Powerbuilt 648691 O2 Sensor Puller which made pulling the plug in tight spaces a lot easier.

Perfect fit. Here's how I did the job in brief. 1) Clear the Check Engine light with a code reader, then remove the driver's seat. 2) Lift up the lower rear carpet near the center console and locate the rubber boot next to it with the wire connector. 3) Disconnect the cable and slide the cuff together with the cable through the hole in the cabin covering the cuff. 4) Unscrew the 2 brackets holding the wiring harness from the catalytic converter. 5) Use a Powerbuilt 648691 Offset Puller to…