Header banner
Revain logoHome Page
dernord bulkhead compression stainless weldless logo

DERNORD Bulkhead Compression Stainless Weldless Review

4

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🍶 Home Brewing & Wine Making Supplies, 🍽️ Kitchen & Dining

View on AmazonView on ЯM

Media

(4)
img 1 attached to DERNORD Bulkhead Compression Stainless Weldless
img 2 attached to DERNORD Bulkhead Compression Stainless Weldless
img 3 attached to DERNORD Bulkhead Compression Stainless Weldless
img 4 attached to DERNORD Bulkhead Compression Stainless Weldless

Description of DERNORD Bulkhead Compression Stainless Weldless

Connection Size: Fits 1.5”TC(50.5mm Ferrule OD). Material: 304 stainless construction and high heat compatible silicone gaskets. Easy to Install: Tri Clamp weldless bulkhead flange allows you to add a TC port to any tank or kettle without welding. Tight Seal: Drill a hole on any vessel and tighen the locknut with 2pcs food grade gaskets. Application: Suitable for kettles, beer kegs, cola kegs, soda buckets with a diameter less than 12 inch.

Reviews

Global ratings 4
  • 5
    2
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Ideal for the kitchen and dining room

Fits in the cork hole on top of my Anvil brew bucket, allowing me to add a temp sensor and TC fitting to an MFL closed equipment fitting

Pros
  • Home brewing and winemaking
Cons
  • Approximately

Revainrating 3 out of 5

not suitable for Dernord heaters

ULWD Dernord wave heaters are too large to fit through this triple clamp. The hole size is not as big as other seamless fittings. Ordered 2, returned 1 for this reason.

Pros
  • Home & Kitchen
Cons
  • Fast OK

Revainrating 3 out of 5

Does not fit heating element

The hole in the middle is too narrow to put the heating element through. Still a great build overall and I've been very happy with other Denord brewing products in the past. So if you're using it for something other than a heating element, I'm sure it will work just fine.

Pros
  • Pots, kettles and accessories
Cons
  • Some disadvantages

Revainrating 5 out of 5

Works with Anvil Bucket Fermenter

I wasn't sure how it would fit my Anvil fermenter. But it turned out to be good quality. I also bought a similar baffle from Anvil for my other fermentor and I like the Dernord better. The Dernord is slightly shorter than the Anvil bulkhead and the construction requires a wrench, but the silicone washers on either end eliminate any chance of scratching the fermenter no matter how hard you tighten it (not the same as the Anvil bulkhead). I would buy it again through Anvil Bulkhead.

Pros
  • Brewing
Cons
  • Infinitely Sluggish