👁️ LIDS BY DESIGN (5mm) Eyelid Correcting Strips for Moderate Lift, 80 count" - Enhance Discoverability with LIDS BY DESIGN (5mm) Eyelid Correcting Strips | Moderate Lift | 80 Count Review

I'm sorry that this product is advertised. Doesn't stick and doesn't help. This is a waste of time and money. Attention buyers

That was a game changer for me. I have closed eyes and these little bands just give me an eyelid and open my eyes right up. Once you find the right size, just pop it in and you're done! Takes a little practice but definitely works!

Don't judge all eye stickers by this product. If I had tried Lids By Design first, I would have given up. I can't believe I'm writing this but they are terrible compared to the cheap brand I bought from Revain. I've tried them as they have a specific size range but I'm going back to my old ones which work great. They are too hard easy to fold upside down. I really felt them, they don't look natural on the eyelid. The edges are not narrow enough. You don't want the sticker to be visible around…

Edges constantly rise and are visible. Also, they are visible when you look down. I haven't noticed any eyelid tightening. They don't look natural and you can't apply eyeshadow to hide them.

Tape is hypoallergenic, non-irritating, sticky like mad and no you can't see it. You do NOT lift the lid. So if you have ptosis, don't waste your money. I've tried them for over a week, every size in every spot, and not only do they not work, they make the condition worse by pulling the lid even lower. They're thick and heavy, incredibly hard to come by. Use warm water, not too sharp and almost dangerous tweezers when trying this. If you touch any part of the edge while peeling it off the…

Bought these on a friend's recommendation. They're great if you just want to wear them on your eyelid to help with lifting. I bought a primer specifically for the eyelids to try and apply shadows to. It just doesn't work. I also tried applying shadows directly to it. You just can't wear makeup over it. Also, they are extremely difficult to place. They stick to tweezers, even metal tweezers. The plastic tweezers broke after two attempts. In my opinion this is a huge waste of time and money.

They help a little but they are not fully transparent as advertised. And no matter which corner you tear off the substrate, it will not lie completely flat. This takes a lot of practice. And it would be great if you could order only 4mm size.