🔥 Design Engineering 010127 Titanium Exhaust Heat Wrap with LR Technology - 2" x 50' - Enhance Performance and Durability Review

Revain refuses to give my long negative review with many photos of this counterfeit product. This is my third attempt at writing this review and I'll just skip the photos. THIS IS A FAKE DEI PRODUCT. Real shrink wrap comes in a hard plastic sleeve, not flimsy shrink wrap like direct from China. The real thing is tightly woven and has very little shedding. FIBER OPTIC EVERYWHERE. I was covered and itchy for days. I could literally stick my finger through the fake because the weave is so flimsy…

действительно разочарован, я обернул свои 2 коллектора V8 longtube, я использовал именно эту марку 4 раза в прошлом на мотоциклетный выхлоп, последний раз был 3 года return. I know how to wrap it properly. Whether it has changed or they sent me a fake one, when you pull it, the 2 inch width becomes 1.3-1.5 width. Never did that. but there is SO MUCH FIBERGLASS in this one that I had to throw my clothes away after wrapping my headlines. Shine a bright LED where you used it and you'll see the…

I don't often write reviews but this stuff is awful and I can promise I will never buy it again. Due to the way the cloth is woven, cutting a shorter piece will result in the entire roll eventually unraveling when tightened. They say 2"x50" is enough for a 4 cylinder engine, but after a few headers I ran out of winding before doing 1/3 of the way with my center pipe (I didn't double the winding, so do Do yourself a favor and buy at least two rolls if it's for anything other than a motorcycle…