DEWALT DW2054 4 Inch Compact Magnetic Review

As a weekend warrior/builder, one of the most annoying things I encountered was that annoying wobble I always encountered when using a drill to drive screws. I inevitably ended up removing a few screws and getting frustrated. This little tool did the job, no more wobble and very few stripped screws. Why did it take me so damn long to find this? This pays off in terms of time savings. If you don't have one and are browsing the Revain tools section, you're probably a woodworker, so be sure to add

I had one of these for about a year when I was a contractor and it was great. Eventually it broke so I bought 3 replacement packs. Each of them broke immediately. I recently bought 3 and the first one I opened broke before even a screw was put in. The sleeve literally slipped off again. I didn't even realize it until I heard him bouncing on the floor. They sat on my counter for a while before I put them in my tool bag so it's too late to go back. Now I've bought 6 of these and managed to get…

The guy who wrote the long review on this item is worn out. so they are not very expensive. Yes, you use these things extensively over the course of a year and they wear out, but it's $5 and it's a great bait holder/guide. It's magnetic so your screw stays in place and the guide is super smooth. For those of you who don't know what it is, it's not just another bit head holder, the black part that says Dewalt is actually a sleeve that slides over the bit head and helps guide the screw, and…

Does what it is supposed to do, which makes screwing easier, especially when screwing in wood. The magnetic advantage is simple but makes screwing in a lot easier, especially if you tend to drop screws. If you are working in a limited work area, it is much easier to place the screw on the bit and then place the screw on the work area, rather than holding the screw on the bit with two hands until you drive the bit. your work assignment. Another benefit is the ability to easily detach your drill…

Thought to try longer screws DEWALT Magnetic Drive Guide, 1/4-Inch (DW2054) from PLEXSUPPLY. Had the part a few weeks before I tried it. I opened the box, everything looked fine, and then tried to put a short #2 Phillips in, the bit didn't fit, tried filing the sides a bit, it still didn't fit, so I took the hammer. Thought it would be nice and cozy. After a few hammer blows, I took the drill out and saw where the inside was deformed, even though the sides were aligned. Finished hammering it…