🔩 Durable DEWALT FlexTorq Magnetic Bit Holder, Impact Ready - 2-Inch (DWA2SLVIR) - Enhance Your Tools! Review

The description says it is a 2" bit but it actually only fits a 2 1/4" bit. I didn't realize it until after the return period had passed, so I can't return it (my fault). But bad seller or revain for wrong description!

Magnet works very well but only fits certain bits. Not suitable. The kit contains a bit and it is very thin. Most of the parts you see in the big store are much thicker and this case doesn't fit them.

Does not fit other bits. Not sure if they should be available in the US as the packaging is not in English and I can't find matching bits for these 2 1/4 anywhere online or in major stores. I have an actual 2" magnetic holder and a set of bits and I can find them everywhere so I don't know why it's impossible to find bits for them.

I bought this to hold the bolts over my head. It works but only on mine Dewalt bits. The Milwaukee beats seem to work, but not quite. I suppose it would be too standard for bit makers to standardize sizes, but I guess since they're actually not that expensive it doesn't matter except if you are using this screw holder you will need a pack of Dewalt 2 1/4 inch bits.

They work quite well and hold the screw securely, they are made by Dewalt for Dewalt's quick witted screwdrivers but can be used with a few other similar designs. The biggest problem is not letting the driver's head stick out far enough. You get a hard bit of material to drive the screw in and it will drive it in far enough that it doesn't start removing the head because it just won't let the head go deep enough. But for most tasks it works fine. I would buy it again, that's for sure.

I have an old bit that I can't get it out of. I bought a new one because I really liked it and this new one didn't come with the bit already I could see the ball bearings that held the racquet in place so I put the old one in a vise and used a screwdriver and a hammer to pry it off the old/bad part Now I need to find a bit that does too fits this old and new one. I didn't buy a new bit at the same time because I just wanted to see the new one and how it works. Plus it was cheap. I also have a…