🔧 Dorman 03415B Exhaust Manifold Mounting Kit Review

I used these to install headers on the Toda Style 1320 CRV. They fit well and were the right length. You need extended studs like these when installing aftermarket headers.

They will NOT fit the Toyota 4Runner 3.4L. I think they should photograph the box from the side because it says what cars they are for. It would be very helpful and they would sell more of it. Looks like good quality pins

As the name suggests the quality is as good as Honda but at a much lower price. If you need to replace old cleats, do yourself a favor and buy them. It can also be used for the intake manifold. They are the same size/length as the exhaust manifold studs.

M8 - 1.25 40mm Turbo Fits perfectly on my 2009 Mini Cooper S. Used to mount the turbocharger on the manifold and the downpipe on the attaching the turbo. If you want to mount the manifold to the block you may need threads up to M8-1.25 48mm. Saved a lot of money with these compared to $10 for a BMW hairpin.

I needed new studs for my turbocharger on my 2015 Veloster Turbo. I removed the catalytic converter to clean it and also removed that horrible knee from the catalytic converter to the turbo outlet. One of the nuts was stuck on a bolt and I couldn't loosen it. Luckily the whole hairpin came out. I decided to replace the worn out, rusty bolt with this one. I replaced all 3 and now I have some left.

Revain's Fit Checker said they don't fit my Honda Civic HX but will fit the EX. But after an hour or so of cross-referencing I decided to give them a try because they were so much cheaper than two studs with brass nuts. (Had to buy 5 packs at $4 a pack.) As far as I could tell they fit just perfect, they had the same threads as the original studs and nuts, went in with no problems and still held tight. Also, they are a pack of 9 studs and 9 nuts. They do the job they were designed for and cost…