Header banner
Revain logoHome Page
dorman 800-642 aluminum line splice for 1/2-inch lines logo

Dorman 800-642 Aluminum Line Splice for 1/2-Inch Lines Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🌡️ Engine Cooling & Climate Control, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(3)
img 1 attached to Dorman 800-642 Aluminum Line Splice for 1/2-Inch Lines
img 2 attached to Dorman 800-642 Aluminum Line Splice for 1/2-Inch Lines
img 3 attached to Dorman 800-642 Aluminum Line Splice for 1/2-Inch Lines

Description of Dorman 800-642 Aluminum Line Splice for 1/2-Inch Lines

Save time and money by repairing only the damaged section, not the entire A/C line assembly. Easy to install. Sturdy aluminum construction. Also available as part of Dorman's A/C Line Repair Kit. Backed by team of engineers and quality control specialists in the United States.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

It works out. Try this before you buy a new refrigerant line.

Worked. That's all. I hooked up my AC line in my 2005 Ford F150 with no problems. Honestly I thought it was going to leak but it's been running for 2 months now with no problems. Fantastic. Saved me a lot of money. Try this first before buying a new line.

Pros
  • Sturdy aluminum construction
Cons
  • Available in white only

Revainrating 5 out of 5

GMC Yukon Cooling Line Repaired

The mechanic used these to reinstall new heating and cooling lines. The GMC Yukon that eliminated the cooling leak in the rear ports works well as long as it holds pressure, no leaks and maximum cooling again! Dealer used tools for other installation methods cost over $1200 for the tool alone! Revain parts are cheaper when delivered on time!

Pros
  • Assisted by a US Engineering Team and Quality Control
Cons
  • No Power

Revainrating 1 out of 5

Not good enough for replacement parts

Used to connect a low pressure line. 2 hours. Works great when adding refrigerant to manufacturer specification at a low pressure of 37psi. However, the next day it started leaking slowly because it couldn't handle 110-140psi at atmospheric pressure on the low pressure side when the car was shut down (especially in hot high desert summers). Next thing I know this compound has been popping up everywhere from a refrigerant explosion. Instead, I've used an AN8 (rated at 1500psi and 500ft F) to…

Pros
  • Save time and money by only repairing the damaged section and not the entire A/C line assembly
Cons
  • Ugly packaging